3″ Donut – 3D Printed Bath Bomb Mold

Description

How to Use 3D Printed Bath Bomb Molds1. Prepare the Mold:

• Ensure your sleeve is on a flat surface, such as a table.
• Put the bottom piece of the mold into the outer sleeve.

2. Fill the Mold:

• Fill the mold up to the top of the sleeve with your prepared bath bomb mixture. Do not pack it in tightly; just level it off.

TIP: If you want to place items like dried flowers or coarse salts in your bath bomb, and have them visible at the top of the finished product, use the mold half with the embossed Voyageur Logo in the bottom of your sleeve. First, sprinkle the flowers or salt into this mold half before adding the bath bomb mix. The embossed logo (the “V”) will help you identify which side of the bath bomb will have the embeds.3. Compress the Bath Bomb:

• Place the top half of the mold into the top of the sleeve and press down firmly to compress the two halves together and to create a tight seal.

4. Remove from the Mold:

• Gently move the sleeve up and down to help release the bath bomb. There may be a bit of suction between the sleeve and the mold halves, which can be easily relieved by tapping the sides of the sleeve with the back or side of a metal spoon.
• Once you tapped a few times against all sides,place mold on the table and push the sleeve up to remove.

5. Release the Bath Bomb from the 2 halves:

• After removing the sleeve, use your thumb or index finger to smooth out the exposed ring of the bath bomb.
• Gently tap the top part of the mold with the side of a metal spoon while firmly holding the mold to break the suction.
• Carefully pull the top part of the mold diagonally upward to remove it.
• Next, while gently holding the exposed part of the bath bomb, turn it upside down and place it onto a flat surface, such as a piece of cardboard.

Repeat the process to remove the bottom half of the mold from the finished bath bomb.6. Dry and Package:

Lay the bath bombs onto a flat surface, such as a piece of cardboard for 24 hours to fully dry before packaging.