How to Use 3D Printed Bath Bomb Molds1. Prepare the Mold:
Ensure your sleeve is on a flat surface, such as a table.
Put the bottom piece of the mold into the outer sleeve.
2. Fill the Mold:
Fill the mold up to the top of the sleeve with your prepared bath bomb mixture. Do not pack it in tightly; just level it off.
3. Compress the Bath Bomb:
Place the top half of the mold into the top of the sleeve and press down firmly to compress the two halves together and to create a tight seal.
4. Remove from the Mold:
Gently move the sleeve up and down to help release the bath bomb. There may be a bit of suction between the sleeve and the mold halves, which can be easily relieved by tapping the sides of the sleeve with the back or side of a metal spoon.
Once you tapped a few times against all sides,place mold on the table and push the sleeve up to remove.
5. Release the Embeds from the 2 halves:
After removing the sleeve, use your thumb or index finger to smooth out the exposed ring of the bath bomb.
Gently tap the top part of the mold with the side of a metal spoon while firmly holding the mold to break the suction.
Carefully pull the top part of the mold diagonally upward to remove it.
Next, while gently holding the exposed part of the bath bomb, turn it upside down and place it over a piece of bubble wrap.
Repeat the process to remove the bottom half of the mold from the finished bath bomb.6. Dry and Package:
Lay the embeds onto a piece of bubble wrap for 24 hours to fully dry before using.
